Dear Support Team,
I hope that you are having a great day. My name is Hamza and i am currently working as a Student Research Assistant at Otto von Guericke Universität Magdeburg, Germany along with my Masters.
As a part of my student assitant job, I have developed a model of 9-Bus system and on some of the buses there are Phasor Measurement Units (PMUs) connected. Now I am trying to connect these PMUs with OPEN PDC PMU Tester to get the output in real time. Since i am almost new in this, thus I need help. I have setup the IP address and port number in the I/O Interface of OPAL RT HYPERSIM and same ip adress and port number is set in PMU Connection tester as can be seen.
I am unsure what doesAwaiting configuration frame means? I would also like to mention that I am running this simulation on local host with IP Adress 141.52.44.171. There is also an Hardware simulator available which is connecte with PC using IP address 141.44.52.167. When i am trying to connect with hardware simulator its is ging me an eror that Connection closed by remote device and A connection can not be established because target computer refused the connection
Your response in this regard wil be very helpful for me.
Kind Regards,
Hamza Ansari.
4 posts - 2 participants